FBC on gen2/3 seems to trigger page table errors. No visual
artifacts are visible, and essentially the same FBC
code works on gen4 so these seem entirely spurious. There
are also hints in gen3 bspec indicating that certain bits
in PGTBL_ER are just not wired up correctly in the
hardware.
Ideally we'd want to mask out only the bogus bits, but
sadly there is no mask for PGTBL_ER, and instead we are
forced to mask out all page table errors via EMR :(
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230125185234.21599-6-ville.syrjala@linux.intel.com
Reviewed-by: Vinod Govindapillai <vinod.govindapillai@intel.com>
At least on some platforms (tested on ctg) the way
vgacon does screen blanking seems to flag constant
FIFO underruns, which means we have to be prepared
for them while the driver is loading. Currently
there is a time window between drm_crtc_init() and
intel_sanitize_fifo_underrun_reporting() during
which FIFO underrun reporting is in fact marked as
enabled. Thus we may end up mistakenly detecting
these bogus underruns during driver init.
Close the race by marking FIFO underrun reporting
as disabled prior to even registering the crtc.
intel_sanitize_fifo_underrun_reporting()/etc. will
re-enable it later if needed.
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230125185234.21599-2-ville.syrjala@linux.intel.com
Reviewed-by: Vinod Govindapillai <vinod.govindapillai@intel.com>
The audio logic lives in the transcoder rather than the pipe,
so start tracking it like that.
This is only really important for bigjoiner cases where tracking
by pipe doesn't work at all since intel_audio_codec_{enable,disable}()
won't even be called for the slave pipe. This means the state
checker won't find the ELD for the slave pipe and gets upset.
The PD->has_audio readout does currently work since that gets
read out from the same transcoder for both pipes.
For other cases this doesn't actually matter since it's only
the normal pipe transcoders that are audio capable, whereas
the more special transcoders (EDP/DSI) are not.
v2: Fix kernel docs
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230222151454.24888-1-ville.syrjala@linux.intel.com
Reviewed-by: Uma Shankar <uma.shankar@intel.com>
Closes: https://gitlab.freedesktop.org/drm/intel/-/issues/8222
The DSI code has some local hacks to program TRANS_VBLANK on
TGL+ (ICL DSI transcoders didn't have this register). That
will not work when we need to start using the delayed vblank
(for DSB purposes). Too lazy to figure out what the is going
on there, so just sprinkle FIXMEs in the hopes someone else
will spot them eventually.
v2: Only TRANS_{HBLANK,SET_CONTEXT_LATENCY} still no not
exist for DSI transcoders, only TRANS_VBLANK
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230213225258.2127-12-ville.syrjala@linux.intel.com
Acked-by: Jani Nikula <jani.nikula@intel.com>
On TGL VBLANK.VBLANK_START was the mechanism by which we can
delay the pipe's internal vblank in relation to the transcoder's
vblank. On ADL+ that no longer does anything. Instead we must
now use the new TRANS_SET_CONTEXT_LATENCY register. Program it
accordingly.
And since VBLANK.VBLANK_START is no longer used by the hardware
on ADL+ let's just zero it out to make it stand out in register
dumps. Seeing the zeroed value should hopefully remind people
to check the other register instead.
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230213225258.2127-11-ville.syrjala@linux.intel.com
Acked-by: Jani Nikula <jani.nikula@intel.com>
Define the contents of the transcoder timing registers using
REG_GENMASK() & co. For ease of maintenance let's just define
the bitmasks with the full 16bit width (also used by the
current hand rolled stuff) even though not all bits are actually
used. None of the unsued bits have ever contained anything.
Jani spotted that the CRT load detection code did use narrower
bitmasks, so that is now going to change. But that is fine
since any garbage in the high bits would have been caught by
the state checker that always used the full 16bit masks.
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230213225258.2127-10-ville.syrjala@linux.intel.com
Reviewed-by: Jani Nikula <jani.nikula@intel.com>
Rename PIPECONF to TRANSCONF to make it clear what it actually
applies to.
While the usual convention is to pick the earliers name I think
in this case it's more clear to use the later name. Especially
as even the register offset is in the wrong range (0x70000 vs.
0x60000) and thus makes it look like this is per-pipe.
There is one place in gvt that's doing something with TRANSCONF
while iterating with for_each_pipe(). So that might not be doing
the right thing for TRANSCODER_EDP, dunno. Not knowing what it
does I left it as is to avoid breakage.
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230213225258.2127-5-ville.syrjala@linux.intel.com
Reviewed-by: Jani Nikula <jani.nikula@intel.com>
Name the CPU transcoder timing registers TRANS_FOO rather than
just FOO. This is the modern name, after the pipe/transcoder split
happened. Makes it a bit more obvious whether you pass in a pipe or
a transcoder.
PIPESRC is a bit special as it's a pipe register, even though it
lives in the transcoder registers range (0x60000 instead of 0x70000).
And BCLRPAT I suppose is a transcoder register (since it has something
to do with the timing generator), but it doesn't even exist after gen4
so I left it to use the only name it ever had in bspec.
And while at it let's pass in the correct enum in few more
places why don't we. Although in all those places the distinction
doesn't matter.
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230213225258.2127-4-ville.syrjala@linux.intel.com
Reviewed-by: Jani Nikula <jani.nikula@intel.com>
Restructure intel_bios_port_aux_ch() to resemble the ddc_pin
counterpart, where the intel_bios.c stuff only deals with the
child device definition, and the platform default will come from
elsewhere.
This requires the introduction of AUX_CH_NONE as the value 0
is already taken to mean AUX_CH_A.
v2: Sort includes alphabetically (Ankit)
vCould we ask them to do a BIOS fix for all of them so that
we wouldn't keep getting these bug reports for each model
separately?
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230216231312.32664-1-ville.syrjala@linux.intel.com
Reviewed-by: Ankit Nautiyal <ankit.k.nautiyal@intel.com>
There was a specific SW workaround requested, which should prevent
some watermark issues happening, which requires copying highest
enabled wm level to those disabled wm levels(bit 31 is of course
still needs to be cleared).
This is related to different subsystems like PSR and others, which
may still consult a low power wm values ocassionally, despite those
are disabled. For that reason we need to keep sane values in
correspondent registers, even when those are disabled.
HSDES: 22016115093
v2: Remove redundant WA for ICL and extend this WA for all platforms
starting from SKL, as it seems that we needed this anyway on
all of those(Ville Syrjälä)
Signed-off-by: Stanislav Lisovskiy <stanislav.lisovskiy@intel.com>
Reviewed-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230213164453.5782-1-stanislav.lisovskiy@intel.com
