RZ/G2LC SoM has both 64 GB eMMC and microSD connected to SDHI0.
Both these interfaces are mutually exclusive and the SD0 device
selection is based on the XOR between GPIO_SD0_DEV_SEL and SW1[2]
switch position.
This patch sets GPIO_SD0_DEV_SEL to high in DT. Use the below switch
setting logic for device selection between eMMC and microSD slot
connected to SDHI0.
Set SW1[2] to position OFF for selecting eMMC
Set SW1[2] to position ON for selecting microSD
This patch enables eMMC on RZ/G2LC SMARC platform by default.
Signed-off-by: Biju Das <biju.das.jz@bp.renesas.com>
Reviewed-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com>
Link: https://lore.kernel.org/r/20220117075130.6198-1-biju.das.jz@bp.renesas.com
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
The RZ/V2L SoC is package- and pin-compatible with RZ/G2L, the only
difference being that the RZ/V2L SoC has additional DRP-AI IP (AI
accelerator).
Add initial DTSI for the RZ/V2L SoC with below SoC specific dtsi files
for supporting single core and dual core devices:
r9a07g054l1.dtsi => RZ/V2L R9A07G054L1 SoC specific parts
r9a07g054l2.dtsi => RZ/V2L R9A07G054L2 SoC specific parts
Both the RZ/G2L and RZ/V2L SMARC EVK SoMs are identical apart from the
SoCs used, hence the common dtsi files (rzg2l-smarc*.dtsi) are shared
between the RZ/G2L and RZ/V2L SMARC EVKs. Place holders are added in
device nodes to avoid compilation errors for devices which have not been
enabled yet on the RZ/V2L SoC.
Signed-off-by: Biju Das <biju.das.jz@bp.renesas.com>
Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com>
Link: https://lore.kernel.org/r/20220110134659.30424-11-prabhakar.mahadev-lad.rj@bp.renesas.com
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
This adds nodes for the lsm9ds0 sensor installed on the KF board.
With this patch, the sensor data becomes available over the IIO sysfs
interface.
The interrupt definition is not added yet, because the interrupt lines
of lsm9ds0 are pulled to VCC on the board, which implies a need for
active-low configuration. But the st_sensors drivers currently can't
work with active-low interrupts on this chip.
Signed-off-by: Nikita Yushchenko <nikita.yoush@cogentembedded.com>
Link: https://lore.kernel.org/r/20220112205205.4082026-1-nikita.yoush@cogentembedded.com
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
The RZ/G2L and RZ/G2LC SoCs are similar and they share the same DEVID.
RZ/G2LC has fewer peripherals compared to RZ/G2L.
SSI (3 channels vs 4 channels)
GbEthernet (1 channel vs 2 channels)
SCIFA (4 channels vs 5 channels)
ADC is only supported in RZ/G2L.
Add the initial DTSI for the RZ/G2LC SoC by reusing the common
r9a07g044.dtsi file with unsupported device nodes deleted in the below
SoC specific dtsi files.
r9a07g044c1.dtsi => RZ/G2LC R9A07G044C1 SoC specific parts
r9a07g044c2.dtsi => RZ/G2LC R9A07G044C2 SoC specific parts
Signed-off-by: Biju Das <biju.das.jz@bp.renesas.com>
Reviewed-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com>
Link: https://lore.kernel.org/r/20211216114305.5842-3-biju.das.jz@bp.renesas.com
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Pull more perf tools updates from Arnaldo Carvalho de Melo:
- Fix printing 'phys_addr' in 'perf script'.
- Fix failure to add events with 'perf probe' in ppc64 due to not
removing leading dot (ppc64 ABIv1).
- Fix cpu_map__item() python binding building.
- Support event alias in form foo-bar-baz, add pmu-events and
parse-event tests for it.
- No need to setup affinities when starting a workload or attaching to
a pid.
- Use path__join() to compose a path instead of ad-hoc snprintf()
equivalent.
- Override attr->sample_period for non-libpfm4 events.
- Use libperf cpumap APIs instead of accessing the internal state
directly.
- Sync x86 arch prctl headers and files changed by the new
set_mempolicy_home_node syscall with the kernel sources.
- Remove duplicate include in cpumap.h.
- Remove redundant err variable.
* tag 'perf-tools-for-v5.17-2022-01-22' of git://git.kernel.org/pub/scm/linux/kernel/git/acme/linux:
perf tools: Remove redundant err variable
perf test: Add parse-events test for aliases with hyphens
perf test: Add pmu-events test for aliases with hyphens
perf parse-events: Support event alias in form foo-bar-baz
perf evsel: Override attr->sample_period for non-libpfm4 events
perf cpumap: Remove duplicate include in cpumap.h
perf cpumap: Migrate to libperf cpumap api
perf python: Fix cpu_map__item() building
perf script: Fix printing 'phys_addr' failure issue
tools headers UAPI: Sync files changed by new set_mempolicy_home_node syscall
tools headers UAPI: Sync x86 arch prctl headers with the kernel sources
perf machine: Use path__join() to compose a path instead of snprintf(dir, '/', filename)
perf evlist: No need to setup affinities when disabling events for pid targets
perf evlist: No need to setup affinities when enabling events for pid targets
perf stat: No need to setup affinities when starting a workload
perf affinity: Allow passing a NULL arg to affinity__cleanup()
perf probe: Fix ppc64 'perf probe add events failed' case
Pull ftrace fix from Steven Rostedt:
"Fix s390 breakage from sorting mcount tables.
The latest merge of the tracing tree sorts the mcount table at build
time. But s390 appears to do things differently (like always) and
replaces the sorted table back to the original unsorted one. As the
ftrace algorithm depends on it being sorted, bad things happen when it
is not, and s390 experienced those bad things.
Add a new config to tell the boot if the mcount table is sorted or
not, and allow s390 to opt out of it"
* tag 'trace-v5.17-3' of git://git.kernel.org/pub/scm/linux/kernel/git/rostedt/linux-trace:
ftrace: Fix assuming build time sort works for s390
To speed up the boot process, as mcount_loc needs to be sorted for ftrace
to work properly, sorting it at build time is more efficient than boot up
and can save milliseconds of time. Unfortunately, this change broke s390
as it will modify the mcount_loc location after the sorting takes place
and will put back the unsorted locations. Since the sorting is skipped at
boot up if it is believed that it was sorted at run time, ftrace can crash
as its algorithms are dependent on the list being sorted.
Add a new config BUILDTIME_MCOUNT_SORT that is set when
BUILDTIME_TABLE_SORT but not if S390 is set. Use this config to determine
if sorting should take place at boot up.
Link: https://lore.kernel.org/all/yt9dee51ctfn.fsf@linux.ibm.com/
Fixes: 72b3942a17 ("scripts: ftrace - move the sort-processing in ftrace_init")
Reported-by: Sven Schnelle <svens@linux.ibm.com>
Tested-by: Heiko Carstens <hca@linux.ibm.com>
Signed-off-by: Steven Rostedt (Google) <rostedt@goodmis.org>
Pull Kbuild fixes from Masahiro Yamada:
- Bring include/uapi/linux/nfc.h into the UAPI compile-test coverage
- Revert the workaround of CONFIG_CC_IMPLICIT_FALLTHROUGH
- Fix build errors in certs/Makefile
* tag 'kbuild-fixes-v5.17' of git://git.kernel.org/pub/scm/linux/kernel/git/masahiroy/linux-kbuild:
certs: Fix build error when CONFIG_MODULE_SIG_KEY is empty
certs: Fix build error when CONFIG_MODULE_SIG_KEY is PKCS#11 URI
Revert "Makefile: Do not quote value for CONFIG_CC_IMPLICIT_FALLTHROUGH"
usr/include/Makefile: add linux/nfc.h to the compile-test coverage
Pull bitmap updates from Yury Norov:
- introduce for_each_set_bitrange()
- use find_first_*_bit() instead of find_next_*_bit() where possible
- unify for_each_bit() macros
* tag 'bitmap-5.17-rc1' of git://github.com/norov/linux:
vsprintf: rework bitmap_list_string
lib: bitmap: add performance test for bitmap_print_to_pagebuf
bitmap: unify find_bit operations
mm/percpu: micro-optimize pcpu_is_populated()
Replace for_each_*_bit_from() with for_each_*_bit() where appropriate
find: micro-optimize for_each_{set,clear}_bit()
include/linux: move for_each_bit() macros from bitops.h to find.h
cpumask: replace cpumask_next_* with cpumask_first_* where appropriate
tools: sync tools/bitmap with mother linux
all: replace find_next{,_zero}_bit with find_first{,_zero}_bit where appropriate
cpumask: use find_first_and_bit()
lib: add find_first_and_bit()
arch: remove GENERIC_FIND_FIRST_BIT entirely
include: move find.h from asm_generic to linux
bitops: move find_bit_*_le functions from le.h to find.h
bitops: protect find_first_{,zero}_bit properly
Perf script was failed to print the phys_addr for SPE profiling.
One 'dummy' event is added by SPE profiling but it doesn't have PHYS_ADDR
attribute set, perf script then exits with error.
Now referring to 'addr', use evsel__do_check_stype() to check the type.
Before:
# perf record -e arm_spe_0/branch_filter=0,ts_enable=1,pa_enable=1,load_filter=1,jitter=0,\
store_filter=0,min_latency=0,event_filter=2/ -p 4064384 -- sleep 3
# perf script -F pid,tid,addr,phys_addr
Samples for 'dummy:u' event do not have PHYS_ADDR attribute set. Cannot print 'phys_addr' field.
After:
# perf record -e arm_spe_0/branch_filter=0,ts_enable=1,pa_enable=1,load_filter=1,jitter=0,\
store_filter=0,min_latency=0,event_filter=2/ -p 4064384 -- sleep 3
# perf script -F pid,tid,addr,phys_addr
4064384/4064384 ffff802f921be0d0 2f921be0d0
4064384/4064384 ffff802f921be0d0 2f921be0d0
Reviewed-by: German Gomez <german.gomez@arm.com>
Signed-off-by: Yao Jin <jinyao5@huawei.com>
Cc: Alexander Shishkin <alexander.shishkin@linux.intel.com>
Cc: Hanjun Guo <guohanjun@huawei.com>
Cc: Jiri Olsa <jolsa@redhat.com>
Cc: Mark Rutland <mark.rutland@arm.com>
Cc: Namhyung Kim <namhyung@kernel.org>
Cc: Peter Zijlstra <peterz@infradead.org>
Link: http://lore.kernel.org/lkml/20220121065954.2121900-1-liwei391@huawei.com
Signed-off-by: Wei Li <liwei391@huawei.com>
Signed-off-by: Arnaldo Carvalho de Melo <acme@redhat.com>
When CONFIG_MODULE_SIG_KEY is PKCS#11 URL (pkcs11:*), signing_key.x509
fails to build:
certs/Makefile:77: *** target pattern contains no '%'. Stop.
Due to the typo, $(X509_DEP) contains a colon.
Fix it.
Fixes: b8c96a6b46 ("certs: simplify $(srctree)/ handling and remove config_filename macro")
Signed-off-by: Masahiro Yamada <masahiroy@kernel.org>
This reverts commit cd8c917a56.
Commit 129ab0d2d9 ("kbuild: do not quote string values in
include/config/auto.conf") provided the final solution.
Now reverting the temporary workaround.
Signed-off-by: Masahiro Yamada <masahiroy@kernel.org>
