_DG1_DPCLKA0_CFGCR0 maps between DPLL 0 and 1 with one bit for phy A
and B while _DG1_DPCLKA1_CFGCR0 maps between DPLL 2 and 3 with one
bit for phy C and D.
Reusing _cnl_ddi_get_pll() don't take that into cosideration returing
DPLL 0 and 1 for phy C and D.
That is a regression introduced in the refactor done in
commit 351221ffc5 ("drm/i915: Move DDI clock readout to
encoder->get_config()").
While at it also dropping the macros previously used, not reusing it
to improve readability.
BSpec: 50286
Fixes: 351221ffc5 ("drm/i915: Move DDI clock readout to encoder->get_config()")
Cc: Lucas De Marchi <lucas.demarchi@intel.com>
Cc: Ville Syrjälä <ville.syrjala@linux.intel.com>
Signed-off-by: José Roberto de Souza <jose.souza@intel.com>
Reviewed-by: Lucas De Marchi <lucas.demarchi@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20210630210522.162674-1-jose.souza@intel.com
(cherry picked from commit 3352d86dcd)
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
Add a single point of truth for figuring out the primary/secondary crtc
for bigjoiner instead of duplicating the magic pipe +/- 1 in multiple
places.
Also fix the pipe validity checks to properly take non-contiguous pipes
into account. The current checks may theoretically overflow
i915->pipe_to_crtc_mapping[pipe], albeit with a warning, due to fused
off pipes, as INTEL_NUM_PIPES() returns the actual number of pipes on
the platform, and the check is for INTEL_NUM_PIPES() == pipe + 1.
Prefer primary/secondary terminology going forward.
v2:
- Improved abstractions for pipe validity etc.
Fixes: 8a029c113b ("drm/i915/dp: Modify VDSC helpers to configure DSC for Bigjoiner slave")
Fixes: d961eb20ad ("drm/i915/bigjoiner: atomic commit changes for uncompressed joiner")
Cc: Animesh Manna <animesh.manna@intel.com>
Cc: Manasi Navare <manasi.d.navare@intel.com>
Cc: Vandita Kulkarni <vandita.kulkarni@intel.com>
Reviewed-by: Manasi Navare <manasi.dl.navare@intel.com>
Signed-off-by: Jani Nikula <jani.nikula@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20210610090528.20511-1-jani.nikula@intel.com
(cherry picked from commit 17203224f0)
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
* devcoredump support for display errors
* dpu: irq cleanup/refactor
* dpu: dt bindings conversion to yaml
* dsi: dt bindings conversion to yaml
* mdp5: alpha/blend_mode/zpos support
* a6xx: cached coherent buffer support
* a660 support
* gpu iova fault improvements:
- info about which block triggered the fault, etc
- generation of gpu devcoredump on fault
* assortment of other cleanups and fixes
Signed-off-by: Dave Airlie <airlied@redhat.com>
From: Rob Clark <robdclark@gmail.com>
Link: https://patchwork.freedesktop.org/patch/msgid/CAF6AEGs4=qsGBBbyn-4JWqW4-YUSTKh67X3DsPQ=T2D9aXKqNA@mail.gmail.com
Handling of the interrupt callback lists is done in dpu_core_irq.c,
under the "cb_lock" spinlock. When these operations results in the need
for enableing or disabling the IRQ in the hardware the code jumps to
dpu_hw_interrupts.c, which protects its operations with "irq_lock"
spinlock.
When an interrupt fires, dpu_hw_intr_dispatch_irq() inspects the
hardware state while holding the "irq_lock" spinlock and jumps to
dpu_core_irq_callback_handler() to invoke the registered handlers, which
traverses the callback list under the "cb_lock" spinlock.
As such, in the event that these happens concurrently we'll end up with
a deadlock.
Prior to '1c1e7763a6d4 ("drm/msm/dpu: simplify IRQ enabling/disabling")'
the enable/disable of the hardware interrupt was done outside the
"cb_lock" region, optimitically by using an atomic enable-counter for
each interrupt and an warning print if someone changed the list between
the atomic_read and the time the operation concluded.
Rather than re-introducing the large array of atomics, this change
embraces the fact that dpu_core_irq and dpu_hw_interrupts are deeply
entangled and make them share the single "irq_lock".
Following this step it's suggested that we squash the two parts into a
single irq handling thing.
Fixes: 1c1e7763a6d4 ("drm/msm/dpu: simplify IRQ enabling/disabling")
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Link: https://lore.kernel.org/r/20210611170003.3539059-1-bjorn.andersson@linaro.org
Signed-off-by: Rob Clark <robdclark@chromium.org>
Add adreno_is_{a660,a650_family} helpers and convert update existing
adreno_is_a650 usage based on downstream driver's logic (changing into
adreno_is_a650_family or adding adreno_is_a660).
And add the remaining changes required for A660, again based on
the downstream driver: missing GMU allocations, additional register init,
dummy hfi BW table, cp protect list, entry in gpulist table, hwcg table,
updated a6xx_ucode_check_version check.
Signed-off-by: Jonathan Marek <jonathan@marek.ca>
Link: https://lore.kernel.org/r/20210608172808.11803-6-jonathan@marek.ca
Signed-off-by: Rob Clark <robdclark@chromium.org>
Based on mesa commit daa2ccff7a0201941db3901780d179e2634057d5
Small bit of .c churn in the phy code to adapt to split up of phy
related registers.
Signed-off-by: Rob Clark <robdclark@chromium.org>
Normal DP suspend operation contains two steps, display off followed
by dp suspend, to complete system wide suspending cycle if display is
up at that time. In this case, DP phy will be powered off at display
off. However there is an exception case that depending on the timing
of dongle plug in during system wide suspending, sometimes display off
procedure may be skipped and dp suspend was called directly. In this
case, dp phy is stay at powered on (phy->power_count = 1) so that at
next resume dp driver crash at main link clock enable due to phy is
not physically powered on. This patch will call dp_ctrl_off_link_stream()
to tear down main link and power off phy at dp_pm_suspend() if main link
had been brought up.
Changes in V2:
-- stashed changes into dp_ctrl.c
-- add is_phy_on to monitor phy state
Changes in V3:
-- delete is_phy_on
-- call dp_ctrl_off_link_stream() from dp_pm_suspend()
Changes in V4:
-- delete changes made at dp_power.c
-- move main link status checking to dp_pm_suspend
Changes in V5:
-- correct commit id at Fixes tag
Fixes: 8dbde399044b ("drm/msm/dp: handle irq_hpd with sink_count = 0 correctly)
Signed-off-by: Kuogee Hsieh <khsieh@codeaurora.org>
Tested-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Stephen Boyd <swboyd@chromium.org>
Link: https://lore.kernel.org/r/1622734846-14179-1-git-send-email-khsieh@codeaurora.org
Signed-off-by: Rob Clark <robdclark@chromium.org>
The result of container_of() operations is never NULL unless the embedded
element is the first element of the structure. This is not the case here.
The NULL checks on the result of container_of() are therefore unnecessary
and misleading. Remove them.
This change was made automatically with the following Coccinelle script.
@@
type t;
identifier v;
statement s;
@@
<+...
(
t v = container_of(...);
|
v = container_of(...);
)
...
when != v
- if (\( !v \| v == NULL \) ) s
...+>
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Link: https://lore.kernel.org/r/20210525112904.1747066-1-linux@roeck-us.net
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
[DB: fixed patch subject]
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Rob Clark <robdclark@chromium.org>
The result of container_of() operations is never NULL unless the embedded
element is the first element of the structure. This is not the case here.
The NULL check on the result of container_of() is therefore unnecessary
and misleading. Remove it.
This change was made automatically with the following Coccinelle script.
@@
type t;
identifier v;
statement s;
@@
<+...
(
t v = container_of(...);
|
v = container_of(...);
)
...
when != v
- if (\( !v \| v == NULL \) ) s
...+>
While at it, remove unused but assigned variable hpd in
dp_display_usbpd_attention_cb().
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Link: https://lore.kernel.org/r/20210525032033.453143-1-linux@roeck-us.net
Reviewed-by: Abhinav Kumar <abhinavk@codeaurora.org>
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Rob Clark <robdclark@chromium.org>
clang is a little overzealous with warning about a constant conversion
in an untaken branch of a ternary expression:
drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c:975:48: error: implicit conversion from 'unsigned long long' to 'unsigned long' changes value from 5000000000 to 705032704 [-Werror,-Wconstant-conversion]
.max_pll_rate = (5000000000ULL < ULONG_MAX) ? 5000000000UL : ULONG_MAX,
^~~~~~~~~~~~
Rewrite this to use a preprocessor conditional instead to avoid the
warning.
Fixes: 076437c9e3 ("drm/msm/dsi: move min/max PLL rate to phy config")
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Link: https://lore.kernel.org/r/20210514213032.575161-1-arnd@kernel.org
Reviewed-by: Nathan Chancellor <nathan@kernel.org>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Rob Clark <robdclark@chromium.org>
