- Enable CPU clks on Qualcomm IPQ6018 SoCs
- Enable CPU clks on Qualcomm MSM8996 SoCs
- GPU clk support for Qualcomm SM8150 and SM8250 SoCs
- Audio clks on Qualcomm SC7180 SoCs
- Make defines for bcm63xx-gate clks to use in DT
- Support gate clks on BCM6318 SoCs
- Add HDMI clks for BCM2711 SoCs
- Support BCM2711 SoC firmware clks
* clk-socfpga:
clk: socfpga: agilex: mpu_l2ram_clk should be mpu_ccu_clk
clk: socfpga: agilex: add nand_x_clk and nand_ecc_clk
dt-bindings: agilex: add NAND_X_CLK and NAND_ECC_CLK
* clk-doc:
clk: Clean up kernel-doc errors
clk: <linux/clk-provider.h>: drop a duplicated word
clk: add function documentation for clk_hw_round_rate()
* clk-qcom: (38 commits)
dt-bindings: clock: Fix YAML schemas for LPASS clocks on SC7180
clk: qcom: gcc-sdm660: Fix up gcc_mss_mnoc_bimc_axi_clk
clk: qcom: gcc-sdm660: Add missing modem reset
clk: qcom: lpass: Add support for LPASS clock controller for SC7180
clk: qcom: gcc: Add support for GCC LPASS clock for SC7180
dt-bindings: clock: Add YAML schemas for LPASS clocks on SC7180
clk: qcom: gdsc: Add support to enable retention of GSDCR
clk: qcom: Export gdsc_gx_do_nothing_enable() to modules
clk: qcom: Add graphics clock controller driver for SM8250
clk: qcom: Add graphics clock controller driver for SM8150
clk: qcom: add common gdsc_gx_do_nothing_enable for gpucc drivers
dt-bindings: clock: add SM8250 QCOM Graphics clock bindings
dt-bindings: clock: add SM8150 QCOM Graphics clock bindings
dt-bindings: clock: combine qcom,sdm845-gpucc and qcom,sc7180-gpucc
clk: qcom: gcc: remove unnecessary vco_table from SM8150
clk: qcom: clk-alpha-pll: use the right PCAL_DONE value for lucid pll
clk: qcom: clk-alpha-pll: same regs and ops for trion and lucid
clk: qcom: clk-alpha-pll: remove unused/incorrect PLL_CAL_VAL
clk: qcom: gcc: fix sm8150 GPU and NPU clocks
dt-bindings: clock: Fix qcom,msm8996-apcc yaml syntax
...
* clk-vc5:
clk: vc5: use a dedicated struct to describe the output drivers
dt-bindings: clk: versaclock5: convert to yaml
MAINTAINERS: take over IDT VersaClock 5 clock driver
dt-bindings: clk: versaclock5: fix 'idt' prefix typos
clk: vc5: Add memory check to prevent oops
clk: vc5: fix use of memory after it has been kfree'd
clk: vc5: Enable addition output configurations of the Versaclock
dt: Add additional option bindings for IDT VersaClock
clk: vc5: Allow Versaclock driver to support multiple instances
* clk-bcm: (44 commits)
clk: bcm2835: Do not use prediv with bcm2711's PLLs
dt-bindings: arm: bcm: Add a select to the RPI Firmware binding
clk: bcm: dvp: Add missing module informations
clk: bcm: rpi: Remove the quirks for the CPU clock
clk: bcm2835: Don't cache the PLLB rate
clk: bcm2835: Allow custom CCF flags for the PLLs
Revert "clk: bcm2835: remove pllb"
clk: bcm: rpi: Give firmware clocks a name
clk: bcm: rpi: Discover the firmware clocks
clk: bcm: rpi: Add an enum for the firmware clocks
clk: bcm: rpi: Add DT provider for the clocks
clk: bcm: rpi: Make the PLLB registration function return a clk_hw
clk: bcm: rpi: Split pllb clock hooks
clk: bcm: rpi: Rename is_prepared function
clk: bcm: rpi: Pass the clocks data to the firmware function
clk: bcm: rpi: Add clock id to data
clk: bcm: rpi: Create a data structure for the clocks
clk: bcm: rpi: Use CCF boundaries instead of rolling our own
clk: bcm: rpi: Make sure the clkdev lookup is removed
clk: bcm: rpi: Switch to clk_hw_register_clkdev
...
Contrary to previous SoCs, bcm2711 doesn't have a prescaler in the PLL
feedback loop. Bypass it by zeroing fb_prediv_mask when running on
bcm2711.
Note that, since the prediv configuration bits were re-purposed, this
was triggering miscalculations on all clocks hanging from the VPU clock,
notably the aux UART, making its output unintelligible.
Fixes: 42de9ad400 ("clk: bcm2835: Add BCM2711_CLOCK_EMMC2 support")
Reported-by: Nathan Chancellor <natechancellor@gmail.com>
Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de>
Link: https://lore.kernel.org/r/20200730182619.23246-1-nsaenzjulienne@suse.de
Tested-by: Nathan Chancellor <natechancellor@gmail.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
Need to merge this up to get the IOMEM dependency patch on top that is
broken and fixed in the next commit.
* clk-fixes:
clk: Specify IOMEM dependency for HSDK pll driver
clk: AST2600: Add mux for EMMC clock
clk: mvebu: ARMADA_AP_CPU_CLK needs to select ARMADA_AP_CP_HELPER
The YAML schemas that landed forgot one clock: "bi_tcxo". Presumably
the bindings were developed against the v4 version of the driver and
when the ".name" was removed in v5 of the driver things broke.
While touching this, add the needed includes in each example. I
believe both examples are supposed to be independent of each other.
Let's fix the bindings.
Fixes: 381cc6f97c ("dt-bindings: clock: Add YAML schemas for LPASS clocks on SC7180")
Signed-off-by: Douglas Anderson <dianders@chromium.org>
Link: https://lore.kernel.org/r/20200731133006.1.Iee81b115f5be50d6d69500fe1bda11bba6e16143@changeid
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
For test and debug purposes, it's simple enough to enable or disable
clocks from shell. Add a new debugfs file 'clk_prepare_enable' that
calls clk_prepare_enable() when writing "1" and clk_disable_unprepare()
when writing "0".
This can have security implications, so only support it when the code
has been modified to #define CLOCK_ALLOW_WRITE_DEBUGFS.
Signed-off-by: Mike Tipton <mdtipton@codeaurora.org>
Link: https://lore.kernel.org/r/20200630003024.6282-1-mdtipton@codeaurora.org
[sboyd@kernel.org: Reword commit text and remove comment update]
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
Fixed ops were already identical, this adds support for non-fixed ops by
sharing between trion and lucid.
This also changes the names for trion ops to be consistent with the rest.
Note LUCID_PCAL_DONE is renamed to TRION_PCAL_DONE because it is wrong for
lucid, LUCID_PCAL_DONE should be BIT(27). Next patch will address this.
Signed-off-by: Jonathan Marek <jonathan@marek.ca>
Tested-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Link: https://lore.kernel.org/r/20200709135251.643-4-jonathan@marek.ca
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
Reusing the generic struct vc5_hw_data for all blocks is handy. However it
implies we allocate space the div_int and div_frc fields even for the
output drivers where they are unused, and the clk_output_cfg0 and
clk_output_cfg0_mask fields for all components even though they are used
only for the output drivers.
Use a dedicated struct for the output drivers so that each block uses
exactly the fields it needs, not more.
Signed-off-by: Luca Ceresoli <luca@lucaceresoli.net>
Link: https://lore.kernel.org/r/20200723072603.1795-1-luca@lucaceresoli.net
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
The RaspberryPi firmware binding uses two compatible, include simple-bus.
The select statement generated by default will thus select any node that
has simple-bus, not all of them being the raspberrypi firmware node.
This results in warnings being wrongfully reported. Let's add a custom
select statement to fix that.
Fixes: d4c708c032 ("dt-bindings: arm: bcm: Convert BCM2835 firmware binding to YAML")
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
Link: https://lore.kernel.org/r/20200626115433.125735-1-maxime@cerno.tech
Acked-by: Florian Fainelli <f.fainelli@gmail.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
Pull Rockchip clk driver updates from Heiko Stuebner:
Use poll_timeout functions for pll lock-waiting and move the rk3036 to use
the available lock-status in pll-registers instead of reading it from the
General Register Files. Handle the clock variants on the rk3288w, revert
the mmc sample shift change on rk3328 and make the mac_lbtest clock
critical on rk3188.
* tag 'v5.9-rockchip-clk1' of git://git.kernel.org/pub/scm/linux/kernel/git/mmind/linux-rockchip:
clk: rockchip: add sclk_mac_lbtest to rk3188_critical_clocks
clk: rockchip: Revert "fix wrong mmc sample phase shift for rk3328"
clk: rockchip: use separate compatibles for rk3288w-cru
dt-bindings: clocks: add rk3288w variant compatible
clk: rockchip: Handle clock tree for rk3288w variant
clk: rockchip: convert rk3036 pll type to use internal lock status
clk: rockchip: convert basic pll lock_wait to use regmap_read_poll_timeout
clk: rockchip: convert rk3399 pll type to use readl_relaxed_poll_timeout
When getting the names of the child nodes, kasprintf is used to
allocate memory which is used to create the string for the node
name. Unfortunately, there is no memory check to determine
if this allocation fails, it may cause an error when trying
to get child node name.
This patch will check if the memory allocation fails, and returns
and -ENOMEM error instead of blindly moving on.
Fixes: 260249f929 ("clk: vc5: Enable addition output configurations of the Versaclock")
Suggested-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: Adam Ford <aford173@gmail.com>
Reviewed-by: Luca Ceresoli <luca@lucaceresoli.net>
Link: https://lore.kernel.org/r/20200716122620.4538-1-aford173@gmail.com
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
There are a several places where printing an error message of
init.name occurs after init.name has been kfree'd. Also the failure
message is duplicated each time in the code. Fix this by adding
a registration error failure path for these cases, moving the
duplicated error messages to one common point and kfree'ing init.name
only after it has been used.
Changes also shrink the object code size by 171 bytes (x86-64, gcc 9.3):
Before:
text data bss dec hex filename
21057 3960 64 25081 61f9 drivers/clk/clk-versaclock5.o
After:
text data bss dec hex filename
20886 3960 64 24910 614e drivers/clk/clk-versaclock5.o
Addresses-Coverity: ("Use after free")
Fixes: f491276a51 ("clk: vc5: Allow Versaclock driver to support multiple instances")
Signed-off-by: Colin Ian King <colin.king@canonical.com>
Link: https://lore.kernel.org/r/20200625132736.88832-1-colin.king@canonical.com
Reviewed-by: Luca Ceresoli <luca@lucaceresoli.net>
[sboyd@kernel.org: Drop stray newline]
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
Pull i.MX clk updates from Shawn Guo:
- Add CAAM clock support for vf610 driver
- Add MU root clock support for imx8mp driver
* tag 'clk-imx-5.9' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
clk: imx: vf610: add CAAM clock
clk: imx8mp: add mu root clk
