Merge series from wangweidong.a@awinic.com:
The Awinic AW88395 is an I2S/TDM input, high efficiency
digital Smart K audio amplifier with an integrated 10.25V
smart boost converter.
Add a DT schema for describing Awinic AW88395 audio amplifiers. They are
controlled using I2C
Merge series from Herve Codina <herve.codina@bootlin.com>:
The Renesas IDT821034 codec is four channel PCM codec with on-chip
filters and programmable gain setting. It also provides SLIC
(Subscriber Line Interface Circuit) signals as GPIOs.
Merge series from Amadeusz Sławiński <amadeuszx.slawinski@linux.intel.com>:
Following is series of fixes and cleanups for core topology code. Few
patches fixing various problems all around and few fixing function
names.
Merge series from Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>:
Audio-Graph-Card and Simple-Audio-Card are similar Card
and are sharing same utils. Thus we can also sharing same schema.
This patch-set fixup some Renesas's "make dtbs_check".
Set the reserved bit 7 in the ANALOG_CTRL_REG for the TAS5720A-Q1 device,
when probing.
The datasheet mentions that the bit should be 1 during reset/powerup.
The device did not initialize before setting this value to 1. So, this
could be a quirk of this device. Or it could be a quirk with the board on
which it was tested.
That is why this patch is separate from the patch that adds support for the
TAS5720A-Q1 device.
Signed-off-by: Steffen Aschbacher <steffen.aschbacher@stihl.de>
Signed-off-by: Alexandru Ardelean <alex@shruggie.ro>
Link: https://lore.kernel.org/r/20230128082744.41849-3-alex@shruggie.ro
Signed-off-by: Mark Brown <broonie@kernel.org>
This change adds support the TAS5720A-Q1 audio codec, in the same driver as
tas5720.
Functionally, this driver is pretty similar to it's TAS5720x variant.
The first 3 registers are the same, so the main control and device
identification can happen with these registers.
The next registers differ.
This variant offers control (in the registers) for 2 speakers, which is
implemented here (in a basic manner).
Signed-off-by: Steffen Aschbacher <steffen.aschbacher@stihl.de>
Signed-off-by: Alexandru Ardelean <alex@shruggie.ro>
Link: https://lore.kernel.org/r/20230128082744.41849-2-alex@shruggie.ro
Signed-off-by: Mark Brown <broonie@kernel.org>
This is to be re-used in tas5720_mute() (which is part of the dai_ops) and
also in the tas5720_fault_check_work() hook.
The benefit here isn't too great (now).
It's only when we add support for a new device with a slightly different
regmap that this becomes more useful.
Signed-off-by: Alexandru Ardelean <alex@shruggie.ro>
Link: https://lore.kernel.org/r/20230128082744.41849-1-alex@shruggie.ro
Signed-off-by: Mark Brown <broonie@kernel.org>
In case of using MIXer with Simple Audio Card, it needs below DT.
simple-audio-card,dai-link@1 {
cpu@0 {
...
};
cpu@1 {
...
};
...
};
This case, it requires "reg = <xxx>" which needs #address-cells/#size-cells,
but simple-audio-card.yaml is missing these. This patch adds it.
Without this patch, we will get below warning.
${LINUX}/arch/arm64/boot/dts/renesas/r8a77950-ulcb.dtb: sound: simple-audio-card,dai-link@0: '#address-cells', '#size-cells' do not match any of the regexes: '^codec(@[0-9a-f]+)?', '^cpu(@[0-9a-f]+)?', 'pinctrl-[0-9]+'
From schema: ${LINUX}/Documentation/devicetree/bindings/sound/simple-card.yaml
Link: https://lore.kernel.org/r/167344317928.394453.14105689826645262807.robh@kernel.org
Reported-by: Rob Herring <robh@kernel.org>
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Link: https://lore.kernel.org/r/87cz757rdi.wl-kuninori.morimoto.gx@renesas.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Current renesas,rsnd is requesting #sound-dai-cells, but it is
needed in case of it is using "simple-card", but not needed in case of
"audio-graph". We will get below warning without this patch.
This patch fiup it.
${LINUX}/arch/arm64/boot/dts/renesas/r8a77950-salvator-x.dtb: sound@ec500000: '#sound-dai-cells' is a required property
From schema: ${LINUX}/Documentation/devicetree/bindings/sound/renesas,rsnd.yaml
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Link: https://lore.kernel.org/r/87edrl7rf4.wl-kuninori.morimoto.gx@renesas.com
Signed-off-by: Mark Brown <broonie@kernel.org>
renesas,rsnd.yaml is possible to use ports/port/endpoint if it is using
Audio Graph Card/Card2 for sound. The schema is defined under
audio-graph-port.yaml.
rsnd driver needs "playback/capture" property under endpoint, but it is not
defined in audio-graph-port.yaml. This patch adds missing "playback/capture"
properties under endpoint.
Without this patch, we will get below warning
${LINUX}/arch/arm64/boot/dts/renesas/r8a77950-salvator-x.dtb: sound@ec500000: ports:port@0:endpoint: Unevaluated properties are not allowed ('playback', 'capture' were unexpected)
From schema: ${LINUX}/Documentation/devicetree/bindings/sound/renesas,rsnd.yaml
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Link: https://lore.kernel.org/r/87h6wh7rfj.wl-kuninori.morimoto.gx@renesas.com
Signed-off-by: Mark Brown <broonie@kernel.org>
ak4613 is possible to use Of-graph (Audio-Graph-Card) style,
but we need to indicate it. Otherwise we will get below warning.
This patch add it.
${LINUX}/arch/arm64/boot/dts/renesas/r8a77950-salvator-x.dtb: codec@10: 'port' does not match any of the regexes: '^asahi-kasei,in[1-2]-single-end$', '^asahi-kasei,out[1-6]-single-end$', 'pinctrl-[0-9]+'
From schema: ${LINUX}/Documentation/devicetree/bindings/sound/ak4613.yaml
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Link: https://lore.kernel.org/r/87ilgx7rfp.wl-kuninori.morimoto.gx@renesas.com
Signed-off-by: Mark Brown <broonie@kernel.org>
audio-graph-port is missing "mclk-fs" on ports/port,
it is used not only endpoint. It is already defined on simple-card.
This patch fixup it.
Without this patch, we will get below warning.
${LINUX}/arch/arm64/boot/dts/renesas/r8a77951-ulcb-kf.dtb: audio-codec@44: ports: 'mclk-fs' does not match any of the regexes: '^port@[0-9a-f]+$', 'pinctrl-[0-9]+'
From schema: ${LINUX}/Documentation/devicetree/bindings/sound/ti,pcm3168a.yaml
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Link: https://lore.kernel.org/r/87o7qp7rgp.wl-kuninori.morimoto.gx@renesas.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Walking the dram->cs array was seen as accesses beyond the first array
item by the compiler. Instead, use the array index directly. This allows
for run-time bounds checking under CONFIG_UBSAN_BOUNDS as well. Seen
with GCC 13 with -fstrict-flex-arrays:
../sound/soc/kirkwood/kirkwood-dma.c: In function
'kirkwood_dma_conf_mbus_windows.constprop':
../sound/soc/kirkwood/kirkwood-dma.c:90:24: warning: array subscript 0 is outside array bounds of 'const struct mbus_dram_window[0]' [-Warray-bounds=]
90 | if ((cs->base & 0xffff0000) < (dma & 0xffff0000)) {
| ~~^~~~~~
Cc: Liam Girdwood <lgirdwood@gmail.com>
Cc: Mark Brown <broonie@kernel.org>
Cc: Jaroslav Kysela <perex@perex.cz>
Cc: Takashi Iwai <tiwai@suse.com>
Cc: alsa-devel@alsa-project.org
Signed-off-by: Kees Cook <keescook@chromium.org>
Link: https://lore.kernel.org/r/20230127224128.never.410-kees@kernel.org
Signed-off-by: Mark Brown <broonie@kernel.org>
