dt-bindings: net: ethernet-phy: clarify when compatible must specify PHY ID

Change PHY ID description in ethernet-phy.yaml to clarify that a
PHY ID is required (may -> must) when the PHY requires special
initialization sequence.

Link: https://lore.kernel.org/netdev/20251026212026.GA2959311-robh@kernel.org/
Link: https://lore.kernel.org/netdev/aQIZvDt5gooZSTcp@debianbuilder/

Signed-off-by: Buday Csaba <buday.csaba@prolan.hu>
Acked-by: Conor Dooley <conor.dooley@microchip.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Reviewed-by: Florian Fainelli <florian.fainelli@broadcom.com>
Link: https://patch.msgid.link/64c52d1a726944a68a308355433e8ef0f82c4240.1762157515.git.buday.csaba@prolan.hu
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

Documentation/devicetree/bindings/net/ethernet-phy.yaml

@@ -35,9 +35,13 @@ properties:
         description: PHYs that implement IEEE802.3 clause 45
       - pattern: "^ethernet-phy-id[a-f0-9]{4}\\.[a-f0-9]{4}$"
         description:
-          If the PHY reports an incorrect ID (or none at all) then the
-          compatible list may contain an entry with the correct PHY ID
-          in the above form.
+          PHYs contain identification registers. These will be read to
+          identify the PHY. If the PHY reports an incorrect ID, or the
+          PHY requires a specific initialization sequence (like a
+          particular order of clocks, resets, power supplies), in
+          order to be able to read the ID registers, then the
+          compatible list must contain an entry with the correct PHY
+          ID in the above form.
           The first group of digits is the 16 bit Phy Identifier 1
           register, this is the chip vendor OUI bits 3:18. The
           second group of digits is the Phy Identifier 2 register,