mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git
synced 2026-02-22 17:04:27 -05:00
d7c6082f7e
There are currently 4 PHY drivers that can drive downstream SFPs: marvell.c, marvell10g.c, at803x.c and marvell-88x2222.c. Most of the logic is boilerplate, either calling into generic phylib helpers (for SFP PHY attach, bus attach, etc.) or performing the same tasks with a bit of validation : - Getting the module's expected interface mode - Making sure the PHY supports it - Optionaly perform some configuration to make sure the PHY outputs the right mode This can be made more generic by leveraging the phy_port, and its configure_mii() callback which allows setting a port's interfaces when the port is a serdes. Introduce a generic PHY SFP support. If a driver doesn't probe the SFP bus itself, but an SFP phandle is found in devicetree/firmware, then the generic PHY SFP support will be used, relying on port ops. PHY driver need to : - Register a .attach_port() callback - When a serdes port is registered to the PHY, drivers must set port->interfaces to the set of PHY_INTERFACE_MODE the port can output - If the port has limitations regarding speed, duplex and aneg, the port can also fine-tune the final linkmodes that can be supported - The port may register a set of ops, including .configure_mii(), that will be called at module_insert time to adjust the interface based on the module detected. Reviewed-by: Christophe Leroy <christophe.leroy@csgroup.eu> Reviewed-by: Andrew Lunn <andrew@lunn.ch> Tested-by: Christophe Leroy <christophe.leroy@csgroup.eu> Signed-off-by: Maxime Chevallier <maxime.chevallier@bootlin.com> Link: https://patch.msgid.link/20260108080041.553250-8-maxime.chevallier@bootlin.com Signed-off-by: Jakub Kicinski <kuba@kernel.org>