Files
linux/drivers
Jai Luthra 9206359b2c media: i2c: imx283: Fix hang when going from large to small resolution
When switching between modes (e.g. full resolution to binned),
standby_cancel() previously cleared XMSTA (starting master mode data
output) before the new mode's MDSEL, crop, and timing registers were
programmed in start_streaming(). This caused the sensor to briefly
output MIPI data using the previous mode's configuration.

On receivers like imx-mipi-csis, this leads to FIFO overflow errors
when switching from a higher to a lower resolution, as the receiver is
configured for the new smaller frame size but receives stale
full-resolution data.

Fix this by moving the XMSTA and SYNCDRV register writes from
standby_cancel() to the end of start_streaming(), after all mode,
crop, and timing registers have been configured. Also explicitly stop
master mode (XMSTA=1) when stopping the stream, matching the pattern
used by other Sony sensor drivers (imx290, imx415).

Use named macros IMX283_XMSTA_START/STOP instead of raw 0/BIT(0) for
readability.

Cc: stable@vger.kernel.org
Fixes: ccb4eb4496 ("media: i2c: Add imx283 camera sensor driver")
Signed-off-by: Jai Luthra <jai.luthra@ideasonboard.com>
Tested-by: Kieran Bingham <kieran.bingham@ideasonboard.com>
Reviewed-by: Kieran Bingham <kieran.bingham@ideasonboard.com>
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
2026-03-11 01:05:35 +01:00
..
2026-02-26 21:51:33 +01:00
2026-01-07 21:17:43 +01:00
2026-02-24 17:31:56 +00:00