mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git
synced 2026-08-28 18:05:00 -04:00
353438b310
Add three optional properties to the MAX8903 charger binding to
describe board-level GPIO control of the DC and USB input current
limits:
DC input (TA / DOK pin):
- dc-current-limit-gpios (1..4 GPIOs): mux control lines feeding
the MAX8903 IDC resistor mux;
- dc-current-limit-mapping (uint32-matrix of {microamps,
gpio_bit_pattern} pairs): the available current levels and the
GPIO bit pattern that selects each level.
USB input (USB / UOK pin):
- usb-current-limit-gpios: a single GPIO driving the IUSB pin.
The IUSB pin is silicon-fixed by the MAX8903 datasheet (Pin
Description): low selects 100 mA, high selects 500 mA. Only
the GPIO mapping is board-specific; the current values are
not exposed in DT.
A dependentRequired block ties dc-current-limit-gpios and
dc-current-limit-mapping together so an incomplete DT cannot pass
validation with only one half of the pair.
These let userspace clamp the input draw via the standard
POWER_SUPPLY_PROP_INPUT_CURRENT_LIMIT power_supply attribute. The HP
TouchPad uses both: two TLMM lines select between 0.5 A, 1.0 A,
1.5 A and 2.0 A DC input current limits behind the MAX8903B
charger, and a third TLMM line picks the IUSB 100 mA / 500 mA
limit.
These are purely additive; existing platforms remain unaffected.
Signed-off-by: Herman van Hazendonk <github.com@herrie.org>
Reviewed-by: Rob Herring (Arm) <robh@kernel.org>
Link: https://patch.msgid.link/20260605-submit-power-max8903-dc-limit-v2-1-0c5396e98f14@herrie.org
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>