Implement SPDIF bypass mode. It implies internal SoC
routing of SPDIF input signal to SPDIF output signal. The
test bed requires two boards: B1 configured in bypass mode,
and B2 to feed B1 SPDIF RX port and read B1 SPDIF TX port:
B2 TX -> B1 RX,
B2 RX <- B1 TX.
The test procedure:
a) Boot both boards
b) B2: start "arecord <spdifcard> -r 48kHz | aplay <local DAC>"
c) B2: start "aplay <spdifcard> -r 48kHz <2ch 48kHz audio file>"
d) B1: enable bypass mode:
amixer -cimxspdif cset numid=8,iface=PCM,name='Bypass Mode' on
e) B2: check DAC audio, make sure the same sample rate is used at
steps b) and c), in example above the rate is 48kHz.
f) B1: try to run "aplay" or "arecord" on imxspdif card while in
bypass mode - both must fail until bypass mode is disabled
g) B1: disable bypass mode:
amixer -cimxspdif cset numid=8,iface=PCM,name='Bypass Mode' off
h) B1: check the usual playback and capture on imxspdif card.
During this test try to set bypass mode - must not be allowed
while playback or capture is running.
Signed-off-by: Viorel Suman <viorel.suman@nxp.com>
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1632649760-1651-1-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
With pause and resume test for ARC, there is occasionally
channel swap issue. The reason is that currently driver set
the DPATH out of reset first, then start the DMA, the first
data got from FIFO may not be the Left channel.
Moving DPATH out of reset operation after the dma enablement
to fix this issue.
Fixes: 2856448686 ("ASoC: fsl_xcvr: Add XCVR ASoC CPU DAI driver")
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1631265510-27384-1-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
There is no defer probe when adding platform component to
snd_soc_pcm_runtime(rtd), the code is in snd_soc_add_pcm_runtime()
snd_soc_register_card()
-> snd_soc_bind_card()
-> snd_soc_add_pcm_runtime()
-> adding cpu dai
-> adding codec dai
-> adding platform component.
So if the platform component is not ready at that time, then the
sound card still registered successfully, but platform component
is empty, the sound card can't be used.
As there is defer probe checking for cpu dai component, then register
platform component before cpu dai to avoid such issue.
Fixes: 2856448686 ("ASoC: fsl_xcvr: Add XCVR ASoC CPU DAI driver")
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1630665006-31437-6-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
There is no defer probe when adding platform component to
snd_soc_pcm_runtime(rtd), the code is in snd_soc_add_pcm_runtime()
snd_soc_register_card()
-> snd_soc_bind_card()
-> snd_soc_add_pcm_runtime()
-> adding cpu dai
-> adding codec dai
-> adding platform component.
So if the platform component is not ready at that time, then the
sound card still registered successfully, but platform component
is empty, the sound card can't be used.
As there is defer probe checking for cpu dai component, then register
platform component before cpu dai to avoid such issue.
Fixes: a2388a498a ("ASoC: fsl: Add S/PDIF CPU DAI driver")
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1630665006-31437-5-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
There is no defer probe when adding platform component to
snd_soc_pcm_runtime(rtd), the code is in snd_soc_add_pcm_runtime()
snd_soc_register_card()
-> snd_soc_bind_card()
-> snd_soc_add_pcm_runtime()
-> adding cpu dai
-> adding codec dai
-> adding platform component.
So if the platform component is not ready at that time, then the
sound card still registered successfully, but platform component
is empty, the sound card can't be used.
As there is defer probe checking for cpu dai component, then register
platform component before cpu dai to avoid such issue.
Fixes: 47a70e6fc9 ("ASoC: Add MICFIL SoC Digital Audio Interface driver.")
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1630665006-31437-4-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
There is no defer probe when adding platform component to
snd_soc_pcm_runtime(rtd), the code is in snd_soc_add_pcm_runtime()
snd_soc_register_card()
-> snd_soc_bind_card()
-> snd_soc_add_pcm_runtime()
-> adding cpu dai
-> adding codec dai
-> adding platform component.
So if the platform component is not ready at that time, then the
sound card still registered successfully, but platform component
is empty, the sound card can't be used.
As there is defer probe checking for cpu dai component, then register
platform component before cpu dai to avoid such issue.
Fixes: 43d24e76b6 ("ASoC: fsl_esai: Add ESAI CPU DAI driver")
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1630665006-31437-3-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
There is no defer probe when adding platform component to
snd_soc_pcm_runtime(rtd), the code is in snd_soc_add_pcm_runtime()
snd_soc_register_card()
-> snd_soc_bind_card()
-> snd_soc_add_pcm_runtime()
-> adding cpu dai
-> adding codec dai
-> adding platform component.
So if the platform component is not ready at that time, then the
sound card still registered successfully, but platform component
is empty, the sound card can't be used.
As there is defer probe checking for cpu dai component, then register
platform component before cpu dai to avoid such issue.
Fixes: 4355082149 ("ASoC: Add SAI SoC Digital Audio Interface driver")
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1630665006-31437-2-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
ASoC: Updates for v5.15
Quite a quiet release this time, mostly a combination of cleanups
and a good set of new drivers.
- Lots of cleanups and improvements to the Intel drivers,
including some new systems support.
- New support for AMD Vangoh, CUI CMM-4030D-261, Mediatek
Mt8195, Renesas RZ/G2L Mediatek Mt8195, RealTek RT101P,
Renesas RZ/G2L,, Rockchip RK3568 S/PDIF.
Hi,
this is v2 from my patchset that add support for the TAS2505 to the tlv320aic32x4 driver.
kind regards,
Claudius
Changes from v1:
- clarified commit message of first patch, which add the type value to the struct
- removed unnecessary code to put and get speaker volume
- removed 'Gain' from 'HP Driver Playback Volume' control
- fixed rebase issues
Claudius Heine (3):
ASoC: tlv320aic32x4: add type to device private data struct
ASoC: tlv320aic32x4: add support for TAS2505
ASoC: tlv320aic32x4: dt-bindings: add TAS2505 to compatible
.../bindings/sound/tlv320aic32x4.txt | 1 +
sound/soc/codecs/tlv320aic32x4-i2c.c | 22 ++-
sound/soc/codecs/tlv320aic32x4-spi.c | 23 ++-
sound/soc/codecs/tlv320aic32x4.c | 139 +++++++++++++++++-
sound/soc/codecs/tlv320aic32x4.h | 10 ++
5 files changed, 186 insertions(+), 9 deletions(-)
base-commit: 70585216fe
--
2.32.0
When system enter suspend, the machine driver suspend callback
function will be called, then the cpu driver trigger callback
(SNDRV_PCM_TRIGGER_SUSPEND) be called, it would disable the
interrupt.
But the machine driver suspend and cpu dai driver suspend order
maybe changed, the cpu dai driver's suspend callback is called before
machine driver's suppend callback, then the interrupt is not cleared
successfully in trigger callback.
So need to clear interrupts in cpu dai driver's suspend callback
to avoid such issue.
Fixes: 9cb2b3796e ("ASoC: fsl_spdif: Add pm runtime function")
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Reviewed-by: Fabio Estevam <festevam@gmail.com>
Link: https://lore.kernel.org/r/1624365084-7934-1-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Hi Mark
These are v3 of parsing for daifmt.
I want to add new audio-graph-card2 sound card driver,
and this is last part of necessary soc-core cleanup for it.
Current some drivers are using DT, and then,
snd_soc_of_parse_daifmt() parses daifmt, but bitclock/frame provider
parsing part is one of headache, because we are assuming below both cases.
A) node {
bitclock-master;
frame-master;
...
};
B) link {
bitclock-master = <&xxx>;
frame-master = <&xxx>;
...
};
The original was style A), and style B) was added later.
snd_soc_of_parse_daifmt() parses A) style as original style,
and user need to update to B) style for clock_provider part if needed.
To handle it more flexibile, this patch-set adds new functions
which separates snd_soc_of_parse_daifmt() helper function.
snd_soc_daifmt_parse_format() : format part
snd_soc_daifmt_parse_clock_provider_as_flag() : clock part for style A)
snd_soc_daifmt_parse_clock_provider_as_phandl() : clock part for style B)
snd_soc_daifmt_parse_clock_provider_as_bitmap() : clock part use with _from_bitmap
v1 -> v2
- tidyup parse_clock_provider functions to _as_flag/phandle/bitmap()
- don't exchange code style on each drivers.
v2 -> v3
- use daifmt as much as possible (don't use daiclk) on each driver.
Link: https://lore.kernel.org/r/875yypdxlm.wl-kuninori.morimoto.gx@renesas.com
Link: https://lore.kernel.org/r/87czsvdc4o.wl-kuninori.morimoto.gx@renesas.com
Kuninori Morimoto (8):
ASoC: soc-core: add snd_soc_daifmt_clock_provider_from_bitmap()
ASoC: soc-core: add snd_soc_daifmt_clock_provider_fliped()
ASoC: soc-core: add snd_soc_daifmt_parse_format/clock_provider()
ASoC: atmel: switch to use snd_soc_daifmt_parse_format/clock_provider()
ASoC: fsl: switch to use snd_soc_daifmt_parse_format/clock_provider()
ASoC: meson: switch to use snd_soc_daifmt_parse_format/clock_provider()
ASoC: simple-card-utils: switch to use snd_soc_daifmt_parse_format/clock_provider()
ASoC: soc-core: remove snd_soc_of_parse_daifmt()
include/sound/soc.h | 21 ++++-
sound/soc/atmel/mikroe-proto.c | 9 ++-
sound/soc/fsl/fsl-asoc-card.c | 7 +-
sound/soc/generic/simple-card-utils.c | 16 ++--
sound/soc/meson/meson-card-utils.c | 6 +-
sound/soc/soc-core.c | 109 +++++++++++++++++---------
6 files changed, 106 insertions(+), 62 deletions(-)
--
2.25.1
