The fundamental premise of VRF and l3mdev core code is binding a socket
to a device (l3mdev or netdev with an L3 domain) to indicate L3 scope.
Legacy code resets flowi_oif to the l3mdev losing any original port
device binding. Ben (among others) has demonstrated use cases where the
original port device binding is important and needs to be retained.
This patch handles that by adding a new entry to the common flow struct
that can indicate the l3mdev index for later rule and table matching
avoiding the need to reset flowi_oif.
In addition to allowing more use cases that require port device binds,
this patch brings a few datapath simplications:
1. l3mdev_fib_rule_match is only called when walking fib rules and
always after l3mdev_update_flow. That allows an optimization to bail
early for non-VRF type uses cases when flowi_l3mdev is not set. Also,
only that index needs to be checked for the FIB table id.
2. l3mdev_update_flow can be called with flowi_oif set to a l3mdev
(e.g., VRF) device. By resetting flowi_oif only for this case the
FLOWI_FLAG_SKIP_NH_OIF flag is not longer needed and can be removed,
removing several checks in the datapath. The flowi_iif path can be
simplified to only be called if the it is not loopback (loopback can
not be assigned to an L3 domain) and the l3mdev index is not already
set.
3. Avoid another device lookup in the output path when the fib lookup
returns a reject failure.
Note: 2 functional tests for local traffic with reject fib rules are
updated to reflect the new direct failure at FIB lookup time for ping
rather than the failure on packet path. The current code fails like this:
HINT: Fails since address on vrf device is out of device scope
COMMAND: ip netns exec ns-A ping -c1 -w1 -I eth1 172.16.3.1
ping: Warning: source address might be selected on device other than: eth1
PING 172.16.3.1 (172.16.3.1) from 172.16.3.1 eth1: 56(84) bytes of data.
--- 172.16.3.1 ping statistics ---
1 packets transmitted, 0 received, 100% packet loss, time 0ms
where the test now directly fails:
HINT: Fails since address on vrf device is out of device scope
COMMAND: ip netns exec ns-A ping -c1 -w1 -I eth1 172.16.3.1
ping: connect: No route to host
Signed-off-by: David Ahern <dsahern@kernel.org>
Tested-by: Ben Greear <greearb@candelatech.com>
Link: https://lore.kernel.org/r/20220314204551.16369-1-dsahern@kernel.org
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Export dmabuf handles for GTT BOs so that their contents can be accessed
using SDMA during checkpoint/restore.
v2: Squash in fix from David to set dmabuf handle to invalid for BOs
that cannot be accessed using SDMA during checkpoint/restore.
Signed-off-by: David Yat Sin <david.yatsin@amd.com>
Reviewed-by : Rajneesh Bhardwaj <rajneesh.bhardwaj@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
pstore_dump() is *always* invoked in atomic context (nowadays in an RCU
read-side critical section, before that under a spinlock).
It doesn't make sense to try to use semaphores here.
This is mostly a revert of commit ea84b580b9 ("pstore: Convert buf_lock
to semaphore"), except that two parts aren't restored back exactly as they
were:
- keep the lock initialization in pstore_register
- in efi_pstore_write(), always set the "block" flag to false
- omit "is_locked", that was unnecessary since
commit 959217c84c ("pstore: Actually give up during locking failure")
- fix the bailout message
The actual problem that the buggy commit was trying to address may have
been that the use of preemptible() in efi_pstore_write() was wrong - it
only looks at preempt_count() and the state of IRQs, but __rcu_read_lock()
doesn't touch either of those under CONFIG_PREEMPT_RCU.
(Sidenote: CONFIG_PREEMPT_RCU means that the scheduler can preempt tasks in
RCU read-side critical sections, but you're not allowed to actively
block/reschedule.)
Lockdep probably never caught the problem because it's very rare that you
actually hit the contended case, so lockdep always just sees the
down_trylock(), not the down_interruptible(), and so it can't tell that
there's a problem.
Fixes: ea84b580b9 ("pstore: Convert buf_lock to semaphore")
Cc: stable@vger.kernel.org
Acked-by: Sebastian Andrzej Siewior <bigeasy@linutronix.de>
Signed-off-by: Jann Horn <jannh@google.com>
Signed-off-by: Kees Cook <keescook@chromium.org>
Link: https://lore.kernel.org/r/20220314185953.2068993-1-jannh@google.com
If tcp_bpf_sendmsg is running during a tear down operation we may enqueue
data on the ingress msg queue while tear down is trying to free it.
sk1 (redirect sk2) sk2
------------------- ---------------
tcp_bpf_sendmsg()
tcp_bpf_send_verdict()
tcp_bpf_sendmsg_redir()
bpf_tcp_ingress()
sock_map_close()
lock_sock()
lock_sock() ... blocking
sk_psock_stop
sk_psock_clear_state(psock, SK_PSOCK_TX_ENABLED);
release_sock(sk);
lock_sock()
sk_mem_charge()
get_page()
sk_psock_queue_msg()
sk_psock_test_state(psock, SK_PSOCK_TX_ENABLED);
drop_sk_msg()
release_sock()
While drop_sk_msg(), the msg has charged memory form sk by sk_mem_charge
and has sg pages need to put. To fix we use sk_msg_free() and then kfee()
msg.
This issue can cause the following info:
WARNING: CPU: 0 PID: 9202 at net/core/stream.c:205 sk_stream_kill_queues+0xc8/0xe0
Call Trace:
<IRQ>
inet_csk_destroy_sock+0x55/0x110
tcp_rcv_state_process+0xe5f/0xe90
? sk_filter_trim_cap+0x10d/0x230
? tcp_v4_do_rcv+0x161/0x250
tcp_v4_do_rcv+0x161/0x250
tcp_v4_rcv+0xc3a/0xce0
ip_protocol_deliver_rcu+0x3d/0x230
ip_local_deliver_finish+0x54/0x60
ip_local_deliver+0xfd/0x110
? ip_protocol_deliver_rcu+0x230/0x230
ip_rcv+0xd6/0x100
? ip_local_deliver+0x110/0x110
__netif_receive_skb_one_core+0x85/0xa0
process_backlog+0xa4/0x160
__napi_poll+0x29/0x1b0
net_rx_action+0x287/0x300
__do_softirq+0xff/0x2fc
do_softirq+0x79/0x90
</IRQ>
WARNING: CPU: 0 PID: 531 at net/ipv4/af_inet.c:154 inet_sock_destruct+0x175/0x1b0
Call Trace:
<TASK>
__sk_destruct+0x24/0x1f0
sk_psock_destroy+0x19b/0x1c0
process_one_work+0x1b3/0x3c0
? process_one_work+0x3c0/0x3c0
worker_thread+0x30/0x350
? process_one_work+0x3c0/0x3c0
kthread+0xe6/0x110
? kthread_complete_and_exit+0x20/0x20
ret_from_fork+0x22/0x30
</TASK>
Fixes: 9635720b7c ("bpf, sockmap: Fix memleak on ingress msg enqueue")
Signed-off-by: Wang Yufen <wangyufen@huawei.com>
Signed-off-by: Daniel Borkmann <daniel@iogearbox.net>
Acked-by: John Fastabend <john.fastabend@gmail.com>
Link: https://lore.kernel.org/bpf/20220304081145.2037182-2-wangyufen@huawei.com
This replaces ->set_page_dirty(). It returns a bool instead of an int
and takes the address_space as a parameter instead of expecting the
implementations to retrieve the address_space from the page. This is
particularly important for filesystems which use FS_OPS for swap.
Signed-off-by: Matthew Wilcox (Oracle) <willy@infradead.org>
Tested-by: Damien Le Moal <damien.lemoal@opensource.wdc.com>
Acked-by: Damien Le Moal <damien.lemoal@opensource.wdc.com>
Tested-by: Mike Marshall <hubcap@omnibond.com> # orangefs
Tested-by: David Howells <dhowells@redhat.com> # afs
Print the folio index instead of the pointer, since this is more
useful. We also don't need to use page_file_mapping() as we do not
invalidate swapcache pages. Since this is the only caller of
nfs_wb_page_cancel(), convert it to nfs_wb_folio_cancel().
Signed-off-by: Matthew Wilcox (Oracle) <willy@infradead.org>
Tested-by: Damien Le Moal <damien.lemoal@opensource.wdc.com>
Acked-by: Damien Le Moal <damien.lemoal@opensource.wdc.com>
Tested-by: Mike Marshall <hubcap@omnibond.com> # orangefs
Tested-by: David Howells <dhowells@redhat.com> # afs
In order to allow kprobes to skip the ENDBR instructions at sym+0 for
X86_KERNEL_IBT builds, change _kprobe_addr() to take an architecture
callback to inspect the function at hand and modify the offset if
needed.
This streamlines the existing interface to cover more cases and
require less hooks. Once PowerPC gets fully converted there will only
be the one arch hook.
Signed-off-by: Peter Zijlstra (Intel) <peterz@infradead.org>
Acked-by: Masami Hiramatsu <mhiramat@kernel.org>
Acked-by: Josh Poimboeuf <jpoimboe@redhat.com>
Link: https://lore.kernel.org/r/20220308154318.405947704@infradead.org
Commit 1b8d0300a3 ("scsi: libiscsi: Fix UAF in
iscsi_conn_get_param()/iscsi_conn_teardown()") fixed an UAF in
iscsi_conn_get_param() and introduced 2 tmp_xxx varibles.
We can gracefully fix this UAF with the help of device_del(). Calling
iscsi_remove_conn() at the beginning of iscsi_conn_teardown would make
userspace unable to see iscsi_cls_conn. This way we we can free memory
safely.
Remove iscsi_destroy_conn() since it is no longer used.
Link: https://lore.kernel.org/r/20220310015759.3296841-4-haowenchao@huawei.com
Reviewed-by: Mike Christie <michael.christie@oracle.com>
Signed-off-by: Wenchao Hao <haowenchao@huawei.com>
Signed-off-by: Wu Bo <wubo40@huawei.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
