Here are the corrections needed for the queue ring buffer size
calculation for the following cases:
- Remove the KIQ VM flush ring usage.
- Add the invalidate TLBs packet for gfx10 and gfx11 queue.
- There's no VM flush and PFP sync, so remove the gfx9 real
ring and compute ring buffer usage.
Signed-off-by: Prike Liang <Prike.Liang@amd.com>
Reviewed-by: Christian König <christian.koenig@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Do VRAM accounting when doing migrations to vram to make sure
there is enough available VRAM and migrating to VRAM doesn't evict
other possible non-unified memory BOs. If migrating to VRAM fails,
driver can fall back to using system memory seamlessly.
Signed-off-by: Mukul Joshi <mukul.joshi@amd.com>
Reviewed-by: Felix Kuehling <felix.kuehling@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
During mode-2 reset, pci config space registers are affected at device
side. However, certain platforms have switches which assign virtual BAR
addresses and returns the same even after device is reset. This
affects pci_restore_state() as it doesn't issue another config write, if
the value read is same as the saved value.
Add a workaround to write saved config space values from driver side.
Presently, these switches are in platforms with SMU v13.0.6 SOCs, hence
restrict the workaround only to those.
Signed-off-by: Lijo Lazar <lijo.lazar@amd.com>
Reviewed-by: Asad Kamal <asad.kamal@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Make SVM BOs more likely to get evicted than other BOs. These BOs
opportunistically use available VRAM, but can fall back relatively
seamlessly to system memory. It also avoids SVM migrations evicting
other, more important BOs as they will evict other SVM allocations
first.
Signed-off-by: Felix Kuehling <felix.kuehling@amd.com>
Acked-by: Mukul Joshi <mukul.joshi@amd.com>
Tested-by: Mukul Joshi <mukul.joshi@amd.com>
Reviewed-by: Christian König <christian.koenig@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
The vpe dpm settings should be done before firmware is loaded.
Otherwise, the frequency cannot be successfully raised.
Signed-off-by: Peyton Lee <peytolee@amd.com>
Reviewed-by: Lang Yu <lang.yu@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
When page table BOs were evicted but not validated before
updating page tables, VM is still in evicting state,
amdgpu_vm_update_range returns -EBUSY and
restore_process_worker runs into a dead loop.
v2: Split the BO validation and page table update into two
separate loops in amdgpu_amdkfd_restore_process_bos. (Felix)
1.Validate BOs
2.Validate VM (and DMABuf attachments)
3.Update page tables for the BOs validated above
Fixes: 50661eb1a2 ("drm/amdgpu: Auto-validate DMABuf imports in compute VMs")
Signed-off-by: Lang Yu <Lang.Yu@amd.com>
Acked-by: Christian König <christian.koenig@amd.com>
Reviewed-by: Felix Kuehling <felix.kuehling@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org
Handle case that dma_fence_get_rcu_safe returns NULL.
If restore work is already scheduled, only update its timer. The same
work item cannot be queued twice, so undo the extra queue eviction.
Fixes: 9a1c1339ab ("drm/amdkfd: Run restore_workers on freezable WQs")
Signed-off-by: Felix Kuehling <felix.kuehling@amd.com>
Reviewed-by: Philip Yang <Philip.Yang@amd.com>
Tested-by: Gang BA <Gang.Ba@amd.com>
Reviewed-by: Gang BA <Gang.Ba@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org
Otherwise we can end up with a frame on unsuspend where color management
is not applied when userspace has not committed themselves.
Fixes re-applying color management on Steam Deck/Gamescope on S3 resume.
Signed-off-by: Joshua Ashton <joshua@froggi.es>
Reviewed-by: Harry Wentland <harry.wentland@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
When we removed the hacky start code check we actually didn't took into
account that *all* VRAM pages needs to be CPU accessible.
Clean up the code and unify the handling into a single helper which
checks if the whole resource is CPU accessible.
The only place where a partial check would make sense is during
eviction, but that is neglitible.
Signed-off-by: Christian König <christian.koenig@amd.com>
Fixes: aed01a6804 ("drm/amdgpu: Remove TTM resource->start visible VRAM condition v2")
Reviewed-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
CC: stable@vger.kernel.org
The majority of those where removed in the commit aed01a6804
("drm/amdgpu: Remove TTM resource->start visible VRAM condition v2")
But this one was missed because it's working on the resource and not the
BO. Since we also no longer use a fake start address for visible BOs
this will now trigger invalid mapping errors.
v2: also remove the unused variable
Signed-off-by: Christian König <christian.koenig@amd.com>
Fixes: aed01a6804 ("drm/amdgpu: Remove TTM resource->start visible VRAM condition v2")
CC: stable@vger.kernel.org
Acked-by: Pierre-Eric Pelloux-Prayer <pierre-eric.pelloux-prayer@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[why]
In current implemenation ODM mode is only reset when the last plane is
removed from dc state. For any dc validate we will always remove all
current planes and add new planes. However when switching from no planes
to 1 plane, ODM mode is not reset because no planes get removed. This
has caused an issue where we kept ODM combine when it should have been
remove when a plane is added. The change is to reset ODM mode when
adding the first plane.
Cc: stable@vger.kernel.org
Reviewed-by: Alvin Lee <alvin.lee2@amd.com>
Acked-by: Hamza Mahfooz <hamza.mahfooz@amd.com>
Signed-off-by: Wenjing Liu <wenjing.liu@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
If there are more than one device doing reset in parallel, the first
device will call kfd_suspend_all_processes() to evict all processes
on all devices, this call takes time to finish. other device will
start reset and recover without waiting. if the process has not been
evicted before doing recover, it will be restored, then caused page
fault.
Signed-off-by: Zhigang Luo <Zhigang.Luo@amd.com>
Reviewed-by: Felix Kuehling <felix.kuehling@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[Why]
set_q_mode_offs don't get cleared after GPU reset, nexting SET_Q_MODE
packet to init shadow memory will be skiped, hence there has a page fault.
[How]
VM flush is needed after GPU reset, clear set_q_mode_offs when
emitting VM flush.
Fixes: 8bc75586ea ("drm/amdgpu: workaround to avoid SET_Q_MODE packets v2")
Reviewed-by: Christian König <christian.koenig@amd.com>
Signed-off-by: ZhenGuo Yin <zhenguo.yin@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org
From MES version 0x54, the log entry increased and require the log buffer
size to be increased. The 16k is maximum size agreed
Signed-off-by: shaoyunl <shaoyun.liu@amd.com>
Acked-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
The MES log might slow down the performance for extra step of log the data,
disable it by default and introduce a parameter can enable it when necessary
Signed-off-by: shaoyunl <shaoyun.liu@amd.com>
Reviewed-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
While doing multiple S4 stress tests, GC/RLC/PMFW get into
an invalid state resulting into hard hangs.
Adding a GFX reset as workaround just before sending the
MP1_UNLOAD message avoids this failure.
Signed-off-by: Tim Huang <Tim.Huang@amd.com>
Acked-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Currently, with F32 HWS GPU reset is only when unmap queue fails.
However, if compute queue doesn't repond to preemption request in time
unmap will return without any error. In this case, only preemption error
is logged and Reset is not triggered. Call GPU reset in this case also.
Reviewed-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Harish Kasiviswanathan <Harish.Kasiviswanathan@amd.com>
Reviewed-by: Mukul Joshi <mukul.joshi@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org
Pull Kbuild fixes from Masahiro Yamada:
- Deduplicate Kconfig entries for CONFIG_CXL_PMU
- Fix unselectable choice entry in MIPS Kconfig, and forbid this
structure
- Remove unused include/asm-generic/export.h
- Fix a NULL pointer dereference bug in modpost
- Enable -Woverride-init warning consistently with W=1
- Drop KCSAN flags from *.mod.c files
* tag 'kbuild-fixes-v6.9' of git://git.kernel.org/pub/scm/linux/kernel/git/masahiroy/linux-kbuild:
kconfig: Fix typo HEIGTH to HEIGHT
Documentation/llvm: Note s390 LLVM=1 support with LLVM 18.1.0 and newer
kbuild: Disable KCSAN for autogenerated *.mod.c intermediaries
kbuild: make -Woverride-init warnings more consistent
modpost: do not make find_tosym() return NULL
export.h: remove include/asm-generic/export.h
kconfig: do not reparent the menu inside a choice block
MIPS: move unselectable FIT_IMAGE_FDT_EPM5 out of the "System type" choice
cxl: remove CONFIG_CXL_PMU entry in drivers/cxl/Kconfig
The -Woverride-init warn about code that may be intentional or not,
but the inintentional ones tend to be real bugs, so there is a bit of
disagreement on whether this warning option should be enabled by default
and we have multiple settings in scripts/Makefile.extrawarn as well as
individual subsystems.
Older versions of clang only supported -Wno-initializer-overrides with
the same meaning as gcc's -Woverride-init, though all supported versions
now work with both. Because of this difference, an earlier cleanup of
mine accidentally turned the clang warning off for W=1 builds and only
left it on for W=2, while it's still enabled for gcc with W=1.
There is also one driver that only turns the warning off for newer
versions of gcc but not other compilers, and some but not all the
Makefiles still use a cc-disable-warning conditional that is no
longer needed with supported compilers here.
Address all of the above by removing the special cases for clang
and always turning the warning off unconditionally where it got
in the way, using the syntax that is supported by both compilers.
Fixes: 2cd3271b7a ("kbuild: avoid duplicate warning options")
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Hamza Mahfooz <hamza.mahfooz@amd.com>
Acked-by: Jani Nikula <jani.nikula@intel.com>
Acked-by: Andrew Jeffery <andrew@codeconstruct.com.au>
Signed-off-by: Jani Nikula <jani.nikula@intel.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Masahiro Yamada <masahiroy@kernel.org>
